Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across Addison
Electric gate repair in Addison usually runs $240 – $680 for most operator, motor, and access-control failures, and the work itself typically takes one to three hours once diagnostics are done. The bigger variable in Addison isn’t the repair, it’s scheduling around residents and getting HOA or management-company sign-off before we order parts or start work. We know that because we work Addison’s multifamily gates regularly. If your gate is down, call (877) 265-5743 and we’ll walk through what’s happening before we even dispatch.

Addison packs more shared vehicle gates, keypad entry systems, and loop detectors per square mile than a typical suburb because the town is only about 4.4 square miles and dominated by multifamily and low-rise commercial property. But nearly every one of those gates is controlled by a property manager or HOA rather than an owner-occupant. So Electric Gate Repair here starts with management-company and architectural-approval coordination, not a homeowner handshake. That’s the reality we’ve built our Addison workflow around, and it’s why property managers along Belt Line, Addison Road, and the Dallas North Tollway corridor call us instead of a fence company that does gates as a side trade.
Why Pinehurst Gate Repair Is Addison’s Preferred Electric Gate Repair Company
We’re gate specialists, not generalists. That distinction matters more in Addison than almost anywhere else in Dallas County because the gates here are shared, heavily cycled, and watched closely by property managers who need accountability and paperwork. Our technicians work on nine major gate and gate-operator brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. When a BFT control board fails on a townhome enclave off Addison Road or a FAAC swing arm drags on an apartment entry near Belt Line, we’re not guessing at proprietary spec sheets. We know the boards, the limits, and the failure patterns.
Ronnie Beshears runs our service, and the crews he sends into Addison understand the approval chain here. Before we order a replacement operator or re-skin a slide gate, we confirm the gate style, height, and finish are cleared with the management company or architectural committee. That single step has saved Addison property managers from fines, board disputes, and rework more times than we can count. When residents are locked out of a shared vehicle gate at 6pm, the last thing anyone wants is a repair that has to be redone because it wasn’t approved.
Our response to ZIP 75001 is same-day for active failures whenever we have a crew available, and we schedule diagnostics around resident traffic so property managers aren’t posting closure notices. We’ve done enough work in Addison’s 1980s-2000s apartment complexes and townhome communities to know which gates are original equipment, which have been retrofit, and which access panels bake in the afternoon sun along the Tollway corridor.
Styles & brands we work with





Electric Gate Motor in Addison
An electric gate motor in Addison is a workhorse, often cycling dozens of times per day on a shared apartment or townhome entry, and when it fails, the whole property feels it. Motor repair typically runs $260 – $480 depending on whether the problem is the capacitor, the limit switch, the gearbox, or the motor itself. On slide gates, the motor and rack take the worst of it; on swing gates, the arm and hinge posts do. We diagnose the motor first and always quote the repair before any work begins, so a management company isn’t holding an open-ended invoice.
Motor Replacement vs. Repair
If the motor is older than 8 to 10 years and has already been patched once, replacement often makes more sense than a third repair. We’ll tell you straight. A new operator installed in Addison typically runs $1,400 – $2,600 installed depending on brand, gate size, and whether the existing posts and brackets can be reused. We always confirm architectural approval on finish and style before ordering the replacement unit.
Cycling and Duty Cycles
Addison gates get cycled far more than a single-family driveway gate, so the duty cycle rating on the operator matters. A residential-duty operator installed on a 40-unit townhome entry will burn itself out early. We check the motor’s duty rating against actual daily cycles and recommend accordingly, rather than just swapping in whatever was there before.
Gate Access Control in Addison
Gate access control in Addison means keypads, card readers, intercoms, loop detectors, and the wiring that ties a shared entry to the property’s management system. Access-control repair here runs $180 – $420 for most keypad, reader, and detector faults, and climbs when a control board or an intercom loop is involved. Summer heat is brutal on keypads: we replace sun-cracked keypad housings and faded membrane switches on Tollway-corridor apartment gates every week from June through September.
Keypads and Resident Access
When a keypad fails, two dozen residents can’t get in and the management office starts fielding angry calls before 8am. We test the keypad signal at the board, not just at the keypad, because half the time the keypad is fine and the problem is a chewed wire or a corroded splice at the control box. That diagnostic discipline is what gets the entry back online the same day instead of after three service visits.
Loop Detectors and Safety Sensors
Loop detectors buried in Addison’s asphalt entries fail when the sawcut shifts or water intrusion corrodes the loop wire. We test loop frequency with a meter and confirm UL 325 entrapment protection trips correctly on every repair we touch. After a windstorm, we also re-align photocells and limit arms on shared swing gates, because a slugged post footing at the hinge post turns a small misalignment into a sag correction job fast.

Trusted Brands We Service in Addison
We work on the brand you already have. For Addison’s multifamily and commercial gates, that’s most commonly LiftMaster and DoorKing on the Tollway corridor properties, FAAC and BFT on higher-end townhome enclaves, and Linear and Viking on older apartment retrofit systems. We carry the common boards, caps, remotes, and photocells for these brands in our local stock, so a repair isn’t held hostage by a parts order. Whether your LiftMaster operator is stuck mid-cycle or your FAAC board has lost power, the diagnostic is faster because we know the equipment. Manual or electric, swing or slide, it’s all we do.
Common Electric Gate Repair Problems We See in Addison Homes
- Overheated control boxes in summer: Addison’s afternoon heat cooks control boards and capacitors inside metal enclosures, especially on west-facing gate posts along Belt Line and Addison Road. We add ventilation or relocate the board when overheating is a repeat problem, not just on the first failure.
- Storm misalignment on swing gates: High-wind spring and fall storms knock limit arms, photocells, and loop detectors out of alignment. A slugged post footing at the hinge post makes it worse, and the gate starts sagging within days. We correct the alignment and the footing, not just the symptom.
- Sun-cracked keypads and faded membrane switches: Years of North Texas UV make keypad housings brittle and button labels illegible. Residents end up punching codes blind. We replace the keypad and recommend a hood or shroud on the next install.
- Rack and pinion grit on slide gates: After a windstorm, grit and debris pack into the rack teeth on slide gates and the operator fights the load. That’s how motors overheat and boards trip. We clean, re-tension, and re-lubricate the rack as part of any slide gate repair in Addison.
See the difference
Before
After
Before
After
Before
AfterPricing for Electric Gate Repair in Addison, TX
Here’s what Addison property managers and owners actually pay, based on the work we do in 75001.
- Diagnostic service call: $85 – $125, credited toward the repair.
- Keypad or reader replacement: $180 – $320.
- Loop detector repair or replacement: $240 – $450.
- Limit switch, capacitor, or gearbox repair: $220 – $460.
- Motor replacement (operator install): $1,400 – $2,600, depending on brand, gate size, and whether posts and brackets can be reused.
These are real ranges for Addison’s multifamily-heavy market, where gates are shared and cycled hard. The price is quoted and agreed before any work starts. Always. Call (877) 265-5743 for an exact quote on your gate.
We Also Serve Cities Near Addison
Our crews run Addison calls alongside work in Electric Gate Repair in Addison, plus Carrollton, Farmers Branch, University Park, and Richardson. If your property sits just outside ZIP 75001, chances are we’re already on a nearby route and can reach you the same day without a service-pricing surcharge.
Serving Addison, TX — Our Local Coverage Area
We’re based in the Addison area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Addison
Yes, in most Addison communities you do. Gate style, height, and finish usually fall under the HOA or management company’s architectural guidelines, and ordering a replacement operator or re-skinning a slide gate without sign-off risks fines, a stop-work order, or having to redo the work at your cost. We confirm the approval status with the management company before ordering parts, and if approval is still pending, we can often complete the diagnostic and temporary safety repair while you wait for the board’s answer. Call (877) 265-5743 and we’ll help you figure out what the approval process looks like for your property.
We coordinate directly with the property manager, maintenance supervisor, or HOA board member who authorizes the work, handles resident notice, and signs the invoice. For apartment and townhome gates, that usually means scheduling the repair after resident traffic dies down, providing photos and a written diagnostic for the management file, and handling the access-control programming with whoever manages the resident codes. We’re set up to work the way Addison property managers need, not the way a single-family gate call goes.
In Addison, the most common causes are a misaligned safety photocell, grit packed into a slide gate’s rack and pinion, or a sagging hinge post from a slugged footing, often triggered by windstorms and sometimes aggravated by the hard clay soil around the Tollway corridor. We test the entrapment protection system and the rack alignment first, then check the post footing, because a reversing gate is usually a safety sensor doing its job, not a motor failure. Call (877) 265-5743 and we’ll diagnose it.
Yes, in most cases. We reset the hinge post footing, correct the alignment on the swing arm and limit switches, and confirm the gate opens and closes within the original travel path without a full-day closure. We schedule the work around resident traffic so the property manager doesn’t have to post a closure notice. If the gate needs a full post replacement, we’ll tell you that before we quote, because that’s a bigger job with a longer closure.
LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. That covers the full spectrum of what’s installed on Addison’s apartment, townhome, and commercial gates. We’re familiar with the proprietary boards, limit specs, and common failure points on each brand, which means faster diagnostics and fewer return trips for property managers who need the gate back online now.
Get Your Addison Gate Back Online
On a townhome enclave off Addison Road, a LiftMaster slide gate kept reversing mid-travel during the evening resident rush. Our tech traced it to a misaligned safety photocell and a rack and pinion packed with grit after a spring windstorm, then found the real culprit: a wallowed post footing letting the hinge post shift. We reset the footing, cleaned and re-tensioned the rack, confirmed UL 325 entrapment protection tripped correctly, and ran the repair after resident traffic died down so the property manager never had to post a closure notice.
If your gate is down, sagging, stuck, or refusing to open for residents, call (877) 265-5743 for a free estimate. We’ll get it back to secure and operating the way it should, with the approval coordination handled the way Addison requires.
Written by Ronnie Beshears, Owner at Pinehurst Gate Repair, serving Addison since we started our gate-only practice.