Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across Heath
When an electric gate stops working in Heath, it’s rarely a simple sensor problem. Most of the calls we run here involve long acreage drives, heavy ornamental gates, and power setups that weren’t sized for the job. If your gate is dead, stuck mid-travel, or opening halfway and reversing, we can get a specialist to your Heath property fast. We’re Pinehurst Gate Repair, and electric gates are what we do – not a side trade alongside garage doors and fences. Call (877) 265-5743 for a free estimate, and we’ll diagnose what’s actually wrong before quoting a price.
Heath sits on the east shore of Lake Ray Hubbard, and its large-lot, partially wooded properties are dominated by long, decorative driveway gates – often wrought iron or ornamental aluminum – that must stand up to lake-effect humidity and seasonal wind. That combination means custom hardware and rust-resistant finishes are a daily concern for gate repair crews here. We know these entrances because we service them regularly.
Why Pinehurst Gate Repair Is Heath’s Preferred Electric Gate Repair Company
Our Electric Gate Repair team works exclusively on gates. No overhead doors, no fence panels, no general contracting. That focus means we carry the diagnostic knowledge and parts for the systems Heath homeowners actually have: LiftMaster, FAAC, BFT, Mighty Mule, and others. When a Heath customer calls with an underground operator that won’t cycle, we’re not learning the control board wiring on your driveway. We already know it.
Ronnie Beshears leads our crew, and the standard is simple: identify the real fault, quote the repair openly, and fix it without upselling a replacement the customer doesn’t need. That’s earned us a strong local reputation across Heath and the surrounding cities. Homeowners and property managers in 75032 keep our number because we show up, name the failed component, and get the gate cycling again. No guessing. No parts-swapping until something sticks.
We serve all of Heath, from the lake-side neighborhoods to the acreage homes further east. Whether your gate is at the end of a two-hundred-foot drive or right off Ridge Road, we’ll schedule a visit and give you an honest assessment. Most Heath calls we handle within a day or two, and we’ll always tell you over the phone whether it sounds like a quick fix or a deeper electrical issue.
Styles & brands we work with
Electric Gate Motor in Heath
Electric Gate Motor repair in Heath usually starts with a question of power and load. A motor that burned out, stripped its gear, or trips its overcurrent every cycle on a Heath acreage gate is often undersized for the gate it’s swinging. We remove the motor and operator arm, check the actual load the gate is putting on the drive, and replace the motor or the entire operator with one rated for the panel’s true weight and span.
Motor Replacement and Operator Sizing
A gate motor that hums but won’t move, or one that moves a few feet and reverses, is frequently failing under the load of a heavy ornamental panel. On Heath’s wide driveways, gates are bigger than suburban standard. We size the replacement operator to the actual gate – weight, length, wind exposure – not to whatever was there before. A properly sized operator on a steel post that hasn’t shifted will run quietly for years.
Solar-Powered Operator Diagnosis
Many Heath gates run on solar because the driveway entrance sits too far from the house panel for a practical mains run. The motor itself is rarely the first failure – the sealed battery bank ages out after three to five years, and the motor starves for current. We test the panel output, load-test the batteries, and replace the power module before condemning a motor that was never getting enough voltage to start.
Gate Access Control in Heath
Gate Access Control in Heath covers everything that tells the gate who to open for: keypads, remotes, intercoms, telephone entry, and the control board that ties them together. When a Heath homeowner’s keypad stops responding or the gate opens for every remote except one, the fault is usually in the access control wiring or the receiver, not the physical gate. We trace the circuit, isolate the failed component, and restore only the access methods you want live.
Keypad and Intercom Repair
Heath keypads sit in direct sun and lake wind year-round, so failed digits and cracked housings are common. We replace worn keypad membranes, re-seal enclosures against moisture, and reprogram codes on-site. If your entry intercom crackles or drops calls to the house, we’ll test the line, replace the handset or control board, and confirm the relay actually triggers the gate.
Control Board Replacement
The control board is the brain of the system, and Heath’s clay soils and lightning season aren’t kind to them. Surge damage on underground runs and moisture in the enclosure cause boards to fail in ways that look mechanical: the gate opens but won’t close, or closes and immediately reopens. We stock replacement boards for the major brands we service and can usually swap a failed board same visit.
Trusted Brands We Service in Heath
We work on the gate system you already have. That means LiftMaster and Mighty Mule on the residential side, plus FAAC and BFT on higher-end and commercial operators. Our technicians have hands-on time with all of them, so we’re not reading the manual while your gate stays open. For Heath customers, we carry the common replacement parts locally – control boards, battery modules, limit switches, remote transmitters – which shortens the time between diagnosis and a working gate.
Common Electric Gate Repair Problems We See in Heath Homes
- Dead solar battery banks. On long Heath drives where mains power was never run to the gate, the sealed batteries in solar openers age out every few years. The gate goes dead without warning, usually after a cloudy stretch. We load-test the bank and replace it before the operator itself gets blamed.
- Seized hinges on heavy ornamental panels. Lake Ray Hubbard humidity corrodes the original steel hinge pins and bushings on Heath gates. A seized hinge forces the motor to work against the gate’s own weight, tripping the overcurrent shutoff. We free or replace the hinge, then re-hang the gate so it swings true.
- Post shift from clay soil movement. Heath’s clay contracts in summer heat and swells after rain, slowly moving gate posts out of plumb. The panel still looks fine. The alignment and the operator’s limit settings don’t. We correct the post footing or re-shim the hinge mounts and re-set travel limits.
- Undersized operators on oversized gates. Many Heath gates were custom-built wider and heavier than off-the-shelf operators were rated for. The motor runs hot, strips gears, and dies early. We replace the operator with one sized to the actual panel, not the original spec sheet.
See the difference
Before
After
Before
After
Before
AfterPricing for Electric Gate Repair in Heath, TX
A typical electric gate motor replacement in Heath runs $450 to $900 installed, depending on the operator size and whether we’re reusing the existing post mounts. Control board replacement for LiftMaster, FAAC, or BFT systems usually lands between $250 and $550 with parts. Keypad and remote receiver work is smaller: most Heath keypad repairs come in under $200. Solar battery bank replacement runs $200 to $400. Seized hinge repair and post correction start around $300 and go up if the post has shifted enough to need footing work. Every job is quoted and agreed before we start – you’ll know the number before any parts get ordered or installed. Call (877) 265-5743 for a free estimate on your specific gate.
We Also Serve Cities Near Heath
Pinehurst Gate Repair covers Heath and the surrounding communities, including McLendon-Chisholm, Rockwall, Fate, and Royse City. If you’re just outside Heath’s 75032 boundary on acreage or in a neighboring subdivision, we’re still close by. See our Electric Gate Repair in Heath service area or call (877) 265-5743 to confirm we reach your driveway.
Serving Heath, TX — Our Local Coverage Area
We’re based in the Heath area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in Heath
Usually the solar opener, because the battery bank is aging out. On Heath acreage, solar is the primary power source for most gates, and the sealed batteries last three to five years before they stop holding charge. The gate works after a sunny stretch, then dies after a few cloudy or rainy days. We load-test the bank first. If the batteries are good, we look at the gate hardware – a stiff hinge or shifting post can overload the operator and cause intermittent shutdowns. Call (877) 265-5743 and we’ll test both before recommending any replacement.
No, not usually. A standard residential swing opener is rated for a gate under roughly 600 pounds and 16 feet. Heath’s wide farm-style and ornamental driveway gates frequently exceed both. The operator runs hot, grinds its gears, and fails early. We size the new operator to the actual panel weight and length, and we use heavy-duty operators – FAAC, BFT, or LiftMaster commercial-grade – for these larger Heath entrances.
Your gate’s safety system does that job, and we test it on every repair. Photocells across the gate opening detect a vehicle or person in the path and stop or reverse the panel. The operator’s internal entrapment sensor measures resistance and does the same. On Heath gates in particular, corroded hinge hardware can make the gate move erratically, and that’s when sensors get blamed for faults they didn’t cause. Safety is the one part of a gate repair we never skip – and high-tension springs and moving gate panels are genuinely dangerous, which is why this is professional work, not a DIY job.
The panel is fine; the post has moved. Heath sits on expansive clay that shrinks in dry heat and swells after rain. Over time, the hinge post tilts enough to drop the latch-side corner of the gate, and the panel sags. The operator also has to work harder, which shortens its life. We correct the post by re-setting the footing or installing a steel post-core reinforcement, then re-hang and align the gate. This is a common Heath repair, and the fix outlasts the original install when done correctly.
Yes, we repair and replace keypads, remote receivers, intercoms, and the control boards that run entry access on Heath gates. We re-program codes on-site, weather-seal enclosures against lake humidity, and make sure the gate actually opens when the access system tells it to. If a keypad is dead, a remote won’t pair, or your intercom opens the gate only sometimes, call (877) 265-5743 for a diagnostic visit and we’ll trace the circuit. Estimates are free.
Power and Span: The Real Story of Heath Gate Repair
Because so many Heath properties sit on acreage beyond practical mains reach at the gate, a large share of local electric gate repair calls start with power – dead batteries in solar gate opener setups and undersized above-ground operators asked to swing oversized ornamental gates. On Heath’s wooded, lake-humid lots the fix is usually a properly sized operator and power plan, not just a sensor tweak. A solar panel that kept a small tube gate moving in a suburban side yard cannot carry a twelve-foot ornamental steel panel on a one-acre lake lot. The panel accumulates heat, the batteries fade, and one morning the gate won’t open.
On a wooded acreage drive off Heath’s lake-side lots, our crew answered a call where a heavy ornamental aluminum swing gate had stopped mid-travel on a solar gate opener. The sealed battery bank had aged out and a seized hinge on the hinge post was dragging the operator into overcurrent faults. We replaced the battery module, freed and re-hung the hinge, ran a sag correction on the post footing, and verified the safety photocells before cycling the gate under its own power. That job sums up most of what we see in Heath: power trouble and structural load working together to stop a gate that was never undersized for its site.
North Texas heat, clay soils that shift with moisture, and strong spring and fall storms put constant stress on gate posts and hinges. Sag and misalignment are the top repair calls in Heath, and they’re never just an alignment issue. The post has moved. The hinge has seized. The operator has been fighting the load. We fix the mechanical problem first – the post, the hinge, the panel weight – and then we restore the electrical system so it isn’t straining from day one.
If your Heath gate is down, slow, noisy, or just not behaving like it used to, call Pinehurst Gate Repair at (877) 265-5743. We’ll send a gate specialist, not a generalist, and you’ll get a straight diagnosis and a written price before any work starts. Manual or electric, swing or slide, we’ll get your entrance back to secure.
Written by Ronnie Beshears, Owner at Pinehurst Gate Repair, serving Heath and the Lake Ray Hubbard area.