Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Forney, TX
Gate installation in Forney comes with a set of local conditions most contractors never think about until they’re already on site. The Blackland Prairie clay under Forney expands and contracts through every North Texas wet-dry cycle, which means a gate post set without proper footing will heave within three to five years. We see it constantly in Clements Ranch and the newer subdivisions off FM 548, where builder-grade gates go out of plumb fast. Pinehurst Gate Repair has served Forney since 2013, and we approach every job here, installation or repair, knowing the soil is going to fight the gate. If you need a gate specialist who knows this area’s ground, call us at (877) 265-5743.
Why Forney Homes Are Different
Forney is a fast-growing exurb on the eastern edge of the Dallas – Fort Worth metroplex, and the gate work here splits into two distinct worlds. In the 2000s – 2020s brick and stone veneer subdivisions, gates are mostly builder-installed hardware on small lots: lightweight vinyl or ornamental metal pedestrian gates with undersized operators, sagging hinges, and posts that were set before the soil had settled. In the older farm-and-ranch acreage off FM 741 and FM 2932, the gates are heavy pipe and tube steel on large posts, often welded, and they fail differently: rust at the hinge barrels, cracked welds at stress points, posts leaning from decades of clay movement.
The common thread is the soil. Forney sits on expansive clay that swells when wet and shrinks when dry. That cycle pushes gate posts out of vertical, throws latches out of alignment, and stresses electric operators until control boards burn out trying to move a gate that no longer swings true. Summer heat adds another layer: vinyl gates warp, wooden gates dry and split at the hardware. A gate repair in Forney that ignores the soil is a repair you’ll be paying for again in two years. We re-set posts in concrete instead of just adjusting hinges, because in this town that’s the difference between a fix that lasts and one that doesn’t.
Styles & brands we work with
Our Main Forney Services
Most Forney homeowners call us for one of two reasons: a gate that won’t open or close properly, or an electric system that stopped responding altogether. Here’s what each involves in this part of Kaufman County.
Gate Repair in Forney
Gate repair here usually comes down to the mechanical side: hinges pulling out of brick veneer columns, latch plates misaligned by shifting posts, sagging gates dragging on driveways that have settled unevenly. We rebuild hinge mounts, re-hang gates that have dropped, and weld cracked steel on the older acreage properties. In the newer subdivisions we often find posts that were never set below the clay line, so the fix means digging out, re-setting, and re-plumbing before we touch the gate itself. If your gate is binding or dragging in Forney, read more on our dedicated Gate Repair in Forney page.
Electric Gate Repair in Forney
Electric gate failures in Forney split between two causes: the operator itself and the power or control wiring feeding it. We diagnose LiftMaster, FAAC, and BFT systems down to the board level rather than guessing at the problem. In Forney, storm-driven power surges and clay-induced post movement both shorten operator life, so we check the full circuit and the mechanical alignment when an automated gate stops mid-cycle. If your opener hums but won’t move, or your keypad went dark, the details are on our Electric Gate Repair in Forney page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Forney
Gate installation in Forney means accounting for clay soil, summer heat, and the specific demands of new-construction subdivisions versus older acreage. In Clements Ranch, Travis Ranch, and the neighborhoods south of US 80, gates are often installed before the ground has finished settling, so we set posts below the clay line and brace for movement from day one. On rural properties off the FM roads, installation is a different job: heavy steel gates on large posts, often with automated operators retrofitted to existing fencing. Whether you’re planning a driveway gate for a new build or replacing a gate that’s beyond repair, we handle the full scope. See our Gate Installation hub for details, and call (877) 265-5743 for a written quote.
Automatic Gate Installation
Signs you need it
Your current gate has to be opened and closed by hand, or your existing operator has failed and can’t be economically repaired.
What it costs in Forney
Automatic gate installation in Forney typically runs $3,800 – $5,700 depending on gate size, operator type, and whether new conduit must be trenched.
How we do it
We set reinforced posts below the clay line, hang the gate, mount the operator, run low-voltage power and safety sensors, and program the system before testing full open-close cycles.
Driveway Gate Installation
Signs you need it
Your driveway opening is wider than a standard pedestrian gate, or you need controlled vehicle access to the property.
What it costs in Forney
Driveway gate installation in Forney typically runs $3,200 – $5,200, with sliding gates at the upper end when track work is required.
How we do it
We measure the drive width and slope, order the gate in steel or aluminum to match your fence, set posts to full depth with concrete, and install hinges or track hardware before automating if requested.
What Gate Installation Costs in Forney
| Item | Typical range in Forney |
|---|---|
| Pedestrian gate, manual | $650 – $1,400 |
| Driveway gate, manual | $3,200 – $5,200 |
| Automatic gate with operator | $3,800 – $5,700 |
Do you handle the power run and the safety sensors?
Yes. We trench conduit, pull low-voltage wire, install photo-eye safety sensors and edge protection, and tie the operator into your panel. The full electrical scope is included in our written quote before any work starts.
How long does a gate installation take in Forney?
Most installations take one to two days from post setting to final programming. Clay soil can add curing time for concrete footings, and we won’t hang a gate on posts that haven’t set.
Brands We Service in Forney
We work on Mighty Mule, LiftMaster, FAAC, and BFT systems daily across Forney, along with Viking, Linear, Ghost Controls, DoorKing, and Elite. That multi-brand fluency means we diagnose by board behavior, not guesswork. See our brands for the full list.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Forney, TX
| Service | Typical range in Forney |
|---|---|
| Gate repair, minor mechanical | $120 – $280 |
| Gate repair, major mechanical | $280 – $600 |
| Electric gate repair, board replacement | $270 – $480 |
| Electric gate repair, full operator | $620 – $1,200 |
| Pedestrian gate, manual install | $650 – $1,400 |
| Driveway gate, manual install | $3,200 – $5,200 |
| Automatic gate with operator | $3,800 – $5,700 |
| Welding or fabrication repair | $200 – $600 |
In Forney, post re-setting due to clay movement is the most common add-on that pushes a repair above the base range, and on acreage properties, rusted-through steel often requires fabrication time. Every job is quoted and agreed before we begin work.
Neighborhoods We Serve in Forney
We cover all of Forney’s 75126 ZIP code, from the new-construction streets of Clements Ranch and Travis Ranch to the older acreage off FM 741 and FM 2932, plus the subdivisions along FM 548 and south of US 80. Our typical response window across the Forney area is same-day for urgent gate failures when we’re already working in the corridor.
- Clements Ranch
- Travis Ranch
- Diamond Creek
- Fox Hollow
- Windmill Farms
Service Area – Cities Near Forney
Pinehurst Gate Repair works throughout the eastern Dallas – Fort Worth corridor, and we regularly run jobs in Travis Ranch, TX, Sunnyvale, TX, Talty, TX, and Seagoville, TX. If your gate is down and you’re in one of these nearby communities, call us at (877) 265-5743 and we’ll get you scheduled.
Serving Forney, TX — Our Local Coverage Area
We’re based in the Forney area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Forney
We typically reach Forney addresses within the same day for urgent failures, especially when we already have a technician working in the Mesquite – Forney corridor. On busy weeks it may be next morning for non-urgent repairs, and we’ll tell you the honest window when you call.
Most Forney subdivisions with HOAs, including Clements Ranch and Travis Ranch, have architectural guidelines covering gate style, height, and color. We can install any approved design, but you’ll need to secure the HOA sign-off before installation. Repairs to existing gates typically don’t require approval.
Yes. We service the rural acreage around Forney in the 75126 ZIP and the surrounding FM roads, including properties in Talty and Seagoville. Pipe and tube steel gates, welded frames, and ranch-style driveway entries are work we handle regularly.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Forney Customers Say
"Fixed the immediate problem. He was honest that the operator is near end of life and I should budget for a replacement, which I appreciate even if it wasn't what I wanted to hear."
— Marco Rodriguez"We had a hydraulic arm leaking fluid onto the driveway. Replaced, cleaned up the stain as best he could, and it's been dry for months."
— Arjun Reddy"Hinge post had rotted at the base and the whole swing gate was sagging into the concrete. He rebuilt the post rather than talking us into a whole new gate, which two other companies had pushed for."
— Renee Hayes